Table of Contents
Advertisement
S
S
UPER
ERVER 1027R-WC1R/1027R-WC1RT User's Manual
Figure 6-1. Front and Rear Chassis Views
Power Supplies
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess
cabling out of the airfl ow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
Hot-Swap Drive Bays (10)
PCI Expansion Slots (w/ Riser Card)
Rear I/O Ports (see Section 5-3)
6-2
Control Panel
USB Ports
Advertisement
Table of Contents
