Table of Contents
Advertisement
S
S
UPER
ERVER 1027R-WC1R/1027R-WC1RT User's Manual
5-5
Installing Memory
Caution! Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
Memory Support
The X9DRW-CF31/CTF31 supports up to 1024 GB of ECC Load-Reduced
(LRDIMM), up to 512 GB of ECC Registered (RDIMM) or up to 128 GB of ECC/
non-ECC unbuffered (UDIMM) DDR3-1866/1600/1333/1066/800 SDRAM in 16
DIMM sockets.
DIMM Installation
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots starting with P1-
DIMMA1. See the Memory Installation Tables below.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Use your thumbs to gently press down on both ends of the DIMM module
until it snaps into place in the slot. Repeat for all modules.
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Figure 5-5. DIMM Installation
Notch
Release Tab
Top View of DDR3 Slot
5-8
Front View
Notch should align with the
receptive key point on the
slot.
Release Tab
Notch
Advertisement
Table of Contents
