TP-Link Archer C2600 User Manual page 59

5. Finish the settings according to the following explanations:
Network Destination: The destination IP address that you want to assign to a static route. This IP
address cannot be on the same subnet with the WAN IP or LAN IP of the router. In the example, the
IP address of the company network is the destination IP address, so here enters 172.30.30.1.
Subnet Mask: Determines the destination network with the destination IP address. If the destination
is a single IP address, enter 255.255.255.255; otherwise, enter the subnet mask of the corresponding
network IP. In the example, the destination network is a single IP, so here enters 255.255.255.255.
Default Gateway: The IP address of the gateway device to which the data packets will be sent.
This IP address must be on the same subnet with the router's IP which sends out the data. In the
example, the data packets will be sent to the LAN port of Router 2 and then to the Server, so the
default gateway should be 192.168.0.2.
Interface: Determined by the port (WAN/LAN) that sends out the data packets. In the example, the
data is sent to the gateway through the LAN port, so LAN should be selected.
Description: Enter a description for this static routing entry.
6. Click OK to save the settings.
7. Check the System Routing Table below. If you can find the entry you set in the System Routing
Table, the static routing is set successfully.
Chapter 11 . Customize your network settings 56