TP-Link ARCHER C2700 Quick Installation Manual

Quick Installation Guide
Wi-Fi Router
Images may differ from actual products.
Connect the Hardware
If your internet connection is through an Ethernet cable from the wall instead
of through a DSL / Cable / Satellite modem, connect the Ethernet cable
directly to the router's Internet port, then follow steps 1, 5 and 6 to complete
the hardware connection.
Internet
Power adapter
Modem
1
Install the antennas.
2
Turn off the modem,
and remove the backup
battery if it has one.
3
Connect the modem to the
router's Internet port with an
Ethernet cable.
4
Turn on the modem, and
then wait about 2 minutes
for it to restart.
5
Connect the power
adapter to the router
and turn on the router.
Router
6
Verify that the following LEDs turn solid before
continuing with the configuration.
Power Internet
2.4GHz 5GHz
On On On On
Note: If the 2.4GHz LED and 5GHz LED are off, please press the
Wi-Fi On/Off button on the side panel for 2 seconds, then both LEDs
should turn stable in a few seconds.
For optimum performance, orient the four antennas
as shown in the drawing below.
30°
Power
adapter
30°