The Back Panel - TP-Link Archer C2600 User Manual

Name
(Power)
(Internet)
(Wireless)
(Wireless)
(LAN)
(WPS)
(USB)
Note:
After a device is successfully added to the network by WPS function, the WPS LED will keep on for about 5 minutes and then turn off.

1. 3. 2. The Back Panel

The router's back panel shows the connection ports, buttons and antennas (view from left to right). Refer to the following for
detailed instructions.
Item
LAN1, LAN2, LAN3, LAN4
Internet
Power
Chapter 1 . Get to Know About Your Router
Status
On System initialization completes.
System initialization or firmware upgrade is in process. Do not disconnect or power off the
Flash
router.
Off Power is off. Please ensure that the power adapter is connected correctly.
White The router is connected to the Internet.
Orange The WAN port is connected, but there is no Internet connection.
Off The WAN port is not connected.
On The wireless 2.4GHz band is working properly.
Off The wireless 2.4 GHz band is disabled.
On The wireless 5GHz band is working properly.
Off The wireless 5GHz band is disabled.
On At least one LAN port is connected.
Off No LAN port is connected.
On A wireless device has been successfully added to the network by WPS function.
WPS handshaking is in process and will continue for about 2 minutes. Please press the WPS
Flash button on other wireless devices that you want to add to the network while the LED is
flashing.
Off The router is not in the WPS process.
On The USB device is identified and ready to use.
Flash The USB device is being identified.
No USB device is plugged into the USB port or the USB device is not identified or USB device
Off
has been safely ejected.
These ports (1, 2, 3, 4) connect the router to the local PC(s).
This port is where you will connect the DSL/cable Modem, or Ethernet.
For connecting the router to power socket via the provided power adapter.
Indication
Description
4