TP-Link Archer C2600 User Manual page 10

4 ) Turn on the modem, and then wait about 2 minutes for it to restart.
5 ) Turn on the router.
6 ) Verify that the following LEDs are on and solid before continuing with the configuration.
Note:
If the 2.4G LED and 5G LED
the LEDs again in a few seconds later.
Tips:
For optimum performance, orient the four antennas as shown in the drawing below.
2. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
• Method 2: Wirelessly
Connect wirelessly by using the SSID (Network Name) and Wireless Password/PIN printed on the product label at the bottom
of the router.
• Method 3: Use the WPS button
Wireless devices that support WPS, including Android phones, tablets, most USB network cards, can be connected to your
router through this method.(WPS is not supported by IOS devices.)
Note:
The WPS function cannot be configured if the wireless function of the router is disabled. Also, the WPS function will be disabled if your
wireless encryption is WEP. Please make sure the wireless function is enabled and is configured with the appropriate encryption before
configuring the WPS.
Chapter 2 . Connect the Hardware
Power
2.4G
On
On
are off, please press the Wi-Fi On/Off button on the side panel for 2 seconds and check
30°
Ethernet cable
Internet
5G
On
On
30°
7