Advertisement
Warning!
For protection from dangerous electric shock, the fixture must
be grounded (earthed). The AC mains supply shall be fitted
with a fuse or circuit breaker and ground-fault protection.
•
Following the cord cap manufacturer's instructions, connect the yellow and
green wire to ground (earth), the brown wire to live, and the blue wire to
neutral. The table below shows some pin identification schemes.
yellow/green
I N S T A L L A T I O N
The Juggler can be permanently installed or hung with a clamp (not included), or
it can be placed on the floor as described below. For maximum lamp life, do not
place the fixture directly on or beside a speaker cabinet or other source of strong
vibrations.
Once the Juggler is installed and connected, the focus may be adjusted by
loosening and sliding the focus adjustment knob.
Warning!
Block access below the work area before proceeding. Always
use a secure means of secondary attachment.
To install or hang the Juggler
1 Install the mounting bracket on the
chassis as shown. Place the washers
on the stud before the bracket.
2 Verify that the structure can support
at least 10 times the weight of all
installed fixtures, clamps, cables,
auxiliary equipment, etc.
3 If hanging the fixture with a rigging
c l a m p , v e r i f y t h a t t h e c l a m p i s
undamaged and can bear at least 10 times the fixture's weight. Bolt the clamp
securely to the bracket with a grade 8.8 (minimum) M12 bolt and lock nut, or
as recommended by the clamp manufacturer, through the clamp hole in the
mounting bracket.
6
Wire
brown
blue
Juggler User Manual
Pin
Marking
live
neutral
ground
Screw color
"L"
yellow or brass
"N"
silver
green
Advertisement
