Compressor Types - Trane TC*150-301 Installation Operation & Maintenance

Start Up
Figure 20. Compressor terminal box
Note: The scroll compressor for R22 units uses Trane OIL-42 without substitution. The appropriate
Note: The Copeland, SSA and SPA scroll compressors for R410A units use Trane OIL00094. The
Table 7.
Tonnage C1
150
180
210
240
300
Table 8.
Model
150
180
210
240
300
2. After the compressor and condenser fan have started and operated for approximately 30
3. Check system superheat. Follow the instruction listed on the superheat charging curve in the
4. Repeat steps 1 through 4 for each refrigerant circuit.
5. To stop the SERVICE TEST, turn the main power disconnect switch to the "Off" position or
40
oil charge for a 9 and 10 ton compressor is 8 pints. For a 14 and 15 ton scroll compressor
use 14 pints.
correct Oil for Trane CSHD is Trane OIL00079 or OIL00080. Compressor types are listed in
the following table. The appropriate oil charge is also listed below.

Compressor types

C2
SSA067 SSA067
CSHD105 SPA057
CSHD142 SPA054
CSHD142 SSA083
CSHD120 CSHD120
POE Oil recharge amount (fl. oz.)
C1 C2
56 56
112 52
112 62
112 56
112 106
minutes, observe the operating pressures. Compare the operating pressures to the operating
pressure curve in the Service Facts.
Service Facts. Superheat should be within ±5° F of the superheat chart value.
proceed to the next component start-up procedure. Remove electro mechanical test mode
connections (if applicable).
RT-SVX25C-EN