Service Notice - Pioneer CDJ-2000NXS Service Manual

1

1.3 SERVICE NOTICE

About the self-diagnostic functions for the drives
A
This unit has self-diagnostic functions for the drives in Service mode. Use the self-diagnostic functions to check the drives if
the problem symptom pointed out by the customer is a malfunction related to the drives or if a drive-related error is logged in
the error history.
For details on the self-diagnostic functions for the drives, see "[5] Drive Self-Diagnosis" and "[6] Contents of Drive
Self-Diagnosis" in "6.1 SERVICE MODE."
About the Flash ROM (IC3) in the MAIN Assy
Replacement of the Flash ROM (IC3: DYW1814) in the MAIN Assy is not possible during service, because writing of
the MAC address on the production line is required.
B
Therefore, the Flash ROM (IC3) is not supplied as a service part. If the Flash ROM is defective, replace the whole MAIN Assy.
About the PNLB and CNCT Assys
The PNLB Assy and CNCT Assy are wired with jumper leads. The PNLB Assy (Part No. DWX3338) is supplied as a service
part with the CNCT Assy connected. The CNCT Assy is not supplied individually as a service part.
About work required after replacement of the Traverse Mechanism Assy (09SD)
After replacement of the traverse mechanism Assy (09SD), reset the LD lighting time to zero.
C
How to Reset: See "7 Drive LD life reset" in "[3] Indication of various information" in "6.1 SERVICE MODE."
About transfer of the accumulated LD lighting time data after replacement of the MAIN Assy
This unit is equipped with self-diagnostic functions for the drives in Service mode. The service-life check for the laser
diode (for CDs/DVDs) among the self-diagnostic functions uses the accumulated lighting time for judgment. If it is
7,000 hours or less, the laser diode is judged as OK. The accumulated lighting time of the LD is stored in the Flash ROM
(IC3: DYW1814) in the MAIN Assy. Therefore, after replacement of the MAIN Assy, the accumulated lighting time of the
LD is cleared and proper judgment will not be possible after that. To avoid such a situation, when replacement of the
MAIN Assy is required, transfer the LD accumulated lighting time data.
Before replacement, confirm the drive LD lighting time in Service mode and take note of the time value. After replacement
D
is finished, enter Service mode then change the drive LD lighting time value to what you noted.
For details on how to confirm and change the LD lighting time, see "8 Drive LD life manual input" in "[3] Indication of
various information" in "6.1 SERVICE MODE."
About the iPod cable supplied with this unit
An iPod cable is supplied with this unit. Be sure to use the iPod cable supplied with this unit to connect an iPad with this unit in
order to determine the cause of a charging problem with an iPad. Do not use the standard cable supplied with iPhones for this
purpose, because it does not meet the specifications required for iPads (a voltage drop may result, because it is thin).
The iPod cable supplied with this unit has been registered as service jig.
E
About backup of the UTILITY settings
As this unit is provided with user-settable UTILITY settings (such as the Play mode setting,) it is recommended that you back
up the settings before starting repair. The settings can be stored for backup in a USB memory device or an SD card.
For details on how to back up and restore data, see "g How to Back Up and Restore the Settings" in "8.5 ITEMS
FOR WHICH USER SETTINGS ARE AVAILABLE ."
F
6
1
2
CDJ-2000NXS
2
3
3
4
4