Error Display List - Pioneer CDJ-2000NXS Service Manual

5

[4] Error display list

WAVE display shows "E-XXXX: DISC DRIVE ERROR".
Note: An alarm port is a function which outputs a pulse from the test port of SH and tells an unusual part by the number of pulses.
Error
Display word
code
E-7001 DISC DRIVE ERROR
E-7010 DSP DEVICE ERROR
E-7020 USB-B DEVICE ERROR
E-7021 PHY CHIP ERROR
E-7022 PANEL CPU ERROR
E-7023 GUI CPU ERROR
E-7024 MAIN CPU ERROR
E-7025 CDC DEVICE ERROR
E-7206 AUTH CHIP ERROR
E-7101 INTERRUPT EXCEPTION
E-7201 CANNOT READ DISC
E-8301 CANNOT READ DISC
E-8302 CANNOT PLAY TRACK
E-8303 CANNOT PLAY TRACK
E-8304 UNSUPPORTED FILE FORMAT
E-8305 UNSUPPORTED FILE FORMAT
E-8306 NO FILE
E-8307 USB ACCESS ERROR
E-8308 SD CARD ACCESS ERROR
E-8309 LINK ACCESS ERROR
E-8709 COMMUNICATION ERROR
E-9101 MECHANICAL TIMEOUT
5
6
Contents
The ATAPI drive doesn't function normally.
The DSP doesn't function normally.
The program isn't available for download.
The USB-B controller doesn't function normally.
The PHY CHIP doesn't function normally.
The panel microcomputer doesn't
function normally.
The GUI CPU doesn't function
normally.
The main CPU doesn't function
normally.
CDC for needle pads does not operate
normally.
Apple authentication tip does not
operate normally.
The abnormalities which are not
expected on a main CPU occurred.
TOC Data can't be read.
Abnormalities occurred during starting.
Abnormalities occurred during playback.
The error of buffer memory writing occurred.
The decoding error occurred.
It is the format which is not supported.
The registered file does not exist.
USB apparatus which is not supported
was connected.
MMC (Multi Media Card) was connected.
It ended in the error of the timeout of
continuation 4 times.
GUI CPU and MAIN CPU cannot be
communicated.
Mechanism operation was not
completed within regulation time.
CDJ-2000NXS
6
7
Notes
It becomes this error when communication
with PANEL is not materialized in the
abnormalities in wire connection etc. It
becomes this error when update of PANEL
goes wrong. MAIN detects and an error code
is transmitted to GUI.
It becomes this error when update of GUI goes
wrong. GUI displays an error code
spontaneously in emergency mode.
* If GUI breaks truly, a display will not come
out at all.
It becomes this error when update of MAIN
goes wrong. MAIN transmits an error code to
GUI by emergency mode.
CDC = Capacity Digital Converter
When the communication with MAIN is not
materialized by the abnormalities of connection,
GUI displays an error code spontaneously.
When MAIN does not operate completely, it will
be in this mode.
7
8
A
Alarm port
correspondence
_
_
_
_
B
_
_
C
_
_
D
E
F
41
8