OWC Mercury Elite Pro Dual Assembly Manual & User Manual page 9

6. Using eight of the larger screws from the packet you removed from the inner chassis,
fasten the hard drives into the inner chassis. There are four screw holes on each side of the
inner chassis, as circled below in red.
7. Note that while the inner chassis can slide into both sides of the outer enclosure, there is
only one correct way that will allow the screw holes to line up correctly. To determine the
correct orientation of the outer enclosure with the inner chassis, turn the outer enclosure
on its side and look at the bottom. As shown below, the screw holes at the front of the
outer enclosure are close to the silicone feet. The screw holes at the rear of the outer
enclosure are farther away from the silicone feet.
REAR
OWC DIGITAL - MERCURY ELITE PRO DUAL
7
FRONT
DEVICE SETUP