OWC Mercury Elite Pro Dual Assembly Manual & User Manual page 10

9. Once the front grill of the inner chassis sits flush with the edge of the outer enclosure,
turn the Mercury Elite Pro Dual on its side again to look at the screw holes on the bottom.
You should be able to see that the screw holes in the outer enclosure line up with the
screw holes in the inner chassis. Use the four smaller screws to fasten the inner chassis to
the outer enclosure, as shown below. The assembly of the Mercury Elite Pro Dual is now
complete.
OWC DIGITAL - MERCURY ELITE PRO DUAL
8. Once you have determined the correct
orientation, slide the inner chassis back
into the outer enclosure, as shown to
the left.
8
DEVICE SETUP