7
Control panel
.09
1
3
The control panel consists of display 1 and the function keys described below. The display 1
consists of a single-line alpha-numerical, 7 segment LCD display with 8 symbols. The texts
2 , located above and next to the LCD display, show the respective status of the function
keys and the operating status of the machine. The control panels switches on all LCD-
segments and the horn automatically for a short time during the power-on phase, after
which the lettering PFAFF appears on the display, until the higher-ranking control unit sends
commands to the control panel.
The function keys are located around the display 1 . They are foil-packed without permanent
marking and without contact signal. Fixed functions are allocated to the keys, see Chapter
7.09.02 Function keys.
7
Screen displays
.09.01
● Activated functions are displayed with a triangular marking 3 below or next to the
respective function key.
● In the sewing mode all relevant sewing data is displayed and can be changed directly,
depending on the status of the machine, see also Chapter 10 Sewing .
● During the parameter input the selected parameter number with the corresponding value
is displayed, see Chapter 12.07.02 Example of a parameter input.
7
Function keys
.09.02
The function keys described below are used basically to switch machine functions on and
off.
Each time a key is pressed, this must be confirmed by at least one beep tone. Irrespective
of the machine mode a double beep signal is given if invalid keys are pressed or maximum
values reached.
If a corresponding value has to be set for the activated function, this is carried out with the
corresponding +/- key . By pressing and holding the corresponding +/- key, the relevant
numerical value 4 is changed slowly to begin with. If the corresponding +/- key is held down
longer, the values change more quickly.
(only on machines with Quick-flange motor)
2
SPEED
TE
ERROR
3
3
3 3
A
B
C
D
4
Controls
7 - 5