Presser Foot To Needle Plate Clearance - Pfaff 918 U Instruction Manual

12

Presser foot to needle plate clearance

.05.25
Requirement
When the hand lever is raised, the needle should penetrate exactly in the "needle hole
centre" of the presser foot and the presser foot to needle plate clearance should be 5 mm.
3
Fig. 12 - 26
● Set the zigzag stitch adjustment lever at "0" and the stitch position adjustment lever at "centre".
● Let the presser foot drop onto the needle plate and reduce the pressure on the presser
bar by turning screws 1 .
● Place the feed dog adjustment gauge under the presser foot with the recess at the
bottom.
● Loosen screw 2 and raise hand lever 3 .
● Allow the needle to penetrate the needle hole and align the presser foot in accordance
with the requirement.
● Press the presser bar lifting piece down and tighten screw 2 .
2
Adjustment
+ -
1
81-038
12 - 27