Operating Instructions - Worx WG118E Safety And Operating Manual

ASSEMBLY
1. ASSEMBly Of THE SAfETy GUARd (See fig. A)
Remove the screw from the Safety Guard (4) and fit the
guard to the trimmer head; align the guard so it slides
into the slots located on the trimmer head. Turn the tool
over and secure the Safety Guard onto the trimmer
head with the screw (a) provided.
2. ASSEMBly Of THE EdGER WHEEl
(See fig. B)
With the tool right side up, slide the Edger Wheel (8)
assembly onto the metal plate located on the side of the
trimmer head. make sure the grooves of the Edger Wheel
assembly lock onto the metal plate; you will hear it click
into place.
To remove the wheel assembly, press the release button
(b) on the wheel and pull the wheel assembly upward.

OPERATING INSTRUCTIONS

WARNING: The cutting head continues to
rotate after the trimmer has been switched
off. Wait until it stops before laying the trimmer
down.
• Always wear eye protection. Never lean over the
trimmer head. Rocks or debris can ricochet or be
thrown into the eyes and face and cause blindness
or other serious injury.
• Hold front handle with one hand and auxiliary
handle with the other hand. Keep unit below waist
level. Work only from your right to your left to
ensure debris is thrown away from you. Without
bending over, keep line near and parallel to the
ground (perpendicular when edging) and not
crowded into material being cut.
• Before operating, make sure both trimmer lines
are extended. When trimming, make sure motor is
running at full speed.
• Use only 1.65mm diameter cutting line. Other line
sizes will not properly feed in the trimmer head
and could cause serious injury. Never use other
materials such as wires, string or rope, as this may
break off during cutting and cause serious injury.
1. SPACER GUARd
Push the Flower Guard (5) in when edging and pull
it out before trimming, as shown in Fig C. Before
trimming or edging make sure the Flower Guard is
locked firmly in position.
2-in-1 Grass Trimmer/Edger WG1 18E
a
A
b
B
C
D
7