Table of Contents
Advertisement
BLSL3060 Manual_Layout 1 2/10/2014 5:00 PM Page 17
Installation: inductive loops
WARNING – This product is an accessory or part of a system. Always read and follow the
manufacturer's instructions for the equipment before connecting this product. Comply with all
applicable codes and safety regulations. Failure to do so may result in damage, injury or death.
New Slab Pour
Ty-wrap 1 1/4" PVC Pipe to the top of the rebar in
the size and configuration of the loop (i.e. 4ft x 8ft).
Then ty-wrap the loop to the top of the PVC frame.
This stabilizes the loop during the pour and
separates it from the rebar.
Saw Cut Existing Surface
Cut " deep into the existing surface, place a 45° cut
at the corners to prevent sharp edges from
damaging the loop wire. Notch out for the "T"
connection where the lead wire connects to the
loop. Remove all debris from the finished cut with
compressed air. Place the loop into the saw cut.
Place backer material into the saw cut over the
loop wire and pack tightly. Place a high quality
sealer over the saw cut to seal the surface.
Resurface Asphalt
Saw cut the existing surface 3/4" deep and place a
45° cut at the corners to prevent sharp edges from
damaging the loop wire. Remove all debris from
the finished cut with compressed air. Place sand
over the loop wire to the surface and pack tightly.
Lay new asphalt.
General Installation Guidelines
BLSL3060
Lead-in wire (wire from loop to
detector) must be must be twisted
a minimum of 6 turns/ foot to
avoid the effects of noise or other
interference.
Detection height is approximately 70%
of the shortest side of the loop.
TECHNICAL SUPPORT: (909) 259-6001
Vehicular Loop
Detector Wire
Concrete Slab Cross View
Saw Cut
Concrete Slab Cross View
Saw Cut
Asphalt Re-surface
Recommended # of Turns
Perimeter in Feet
10
20
30-40
50-100
1 - 1 1/4in. PVC Pipe
Steel Rebar
1" Min.
Sealant
Backer-Rod
Vehicular Loop
Detector Wire
New Asphalt
Sand filled Saw Cut
Existing Surface
Vehicular Loop
Detector Wire
# of Turns
5
4
3
2
15
Advertisement
Table of Contents
