Replace Sanding Disc Abrasive - PowerTec BD4800 PRO Owners Manual/Install Manual

• Release sanding belt tension by lift the Tension Lever (i)
toward the Idler Drum (j).
• Remove the used Sanding Belt (k).
• Replace with a new Sanding Belt. If there is an arrow
mark on the inside backing, the arrow should point in the
direction of belt travel.
• Position and center the new Sanding Belt over the Drive
Drum (o) and Idler Drum (j).
• Tighten the belt tension with the Tension Lever (i). Push
the tension lever toward the Drive Drum(o).
• Replace the Dust Cover (h) and Wing Screws with
8
Washers (g).
• Adjust the Bell Tracking Mechanism, Refer to ADJUST
BELT TRACKING MECHANISM section.
• Replace Support Rod and Table Assembly.
Figure 13
h
Figure 14
k
o
g
f
j
i
l
m

REPLACE SANDING DISC ABRASIVE

Refer to Figure 14
• Remove Table Assembly. Remove Support Rod.
• Remove all screws (m) and remove the Disc Cover (l).
• Peel off the used Sanding Disc Abrasive.
• Clean the surface of the Aluminum Disc. Use Solvent to
remove excessive residual adhesive if necessary.
• Peel off the protective paper on the back of the New
Abrasive Disc (n).
• With the adhesive side facing the disc drum, carefully
place the Abrasive Disc (n) onto the center of aluminum
disc.
• Confirm the position is satisfactory before pressing the
Abrasive Disc (n) firmly and evenly against the disc
drum in the entire area.
• Replace the Disc Cover (l) and tighten with screws (m).
• Replace Support Rod and Table Assembly.
e
n