Options
. Setting the LED Indicator:
On
3
J
Off
3
J
(3 pins: Left, Center, Right)
3. Alarm Control/ Light
Control/ Recording Control
(N.O or N.C)
Sec
3
J3
User Define
3
J3
(3 pins: Left, Center, Right)
4. PIR Output Terminals:
+
1
–
N.O.
2
N.C.
4 Hour/Anti-Tamper
Description
To enable/ disable the LED indicator, please
refer to the appropriate dip-switch configuration
shown below:
LED ON: Easy to be identified as a security
LED OFF: No light blinking while detection, less
Switch
J
To setup dwell time of the Alarm Control/ Light
Control/ Recording Control, please refer to the
appropriate dip-switch configuration table shown
below:
Dwell Time Adjustment:
• Set to „Position " to enable default time of
the PIR sensor, fixed: sec.
• Set to „Position " then turn „SVR" clockwise
to extend dwell time of sensor mechanically
and counter clockwise to shorten dwell time
of PIR sensor.
Switch
J3
. Power Input: V DC
. N.C.: Normal Close
N.O.: Normal Open
• Relay Output: 3A 0V AC, 3A 4V DC
9
system.
obvious.
Position 1
On
Position 1
Sec
Position 2
Off
Position 2
User Define