Home Mode; Secure Exit; Home Instant Mode; Manual Bypassing Of Sensors - Linear DVS-2400 Installation & Programming Instructions

HOME MODE

◆
Use this mode when sleeping or when anyone is
staying inside.
◆
Home Mode causes an instant alarm when any
perimeter sensor is triggered.
◆
Home Mode causes a delayed alarm when any
exit/entry sensor is triggered (except in Home
Instant Mode when they are instant).
◆
Alarm siren stops automatically after five
minutes and the system will remain armed.
◆
Home Mode ignores all interior sensors (motion
detectors, etc.).
Arm to Home Mode by entering a user code, and
pressing [ HOME ].
The user can "Quick Arm" to Home Mode from Off
or Chime Mode by holding down the [HOME] key
for two seconds. (Quick arming can be disabled;
see the "Advanced Programming" section of this
manual.)
❇
When the system is armed to the Home Mode,
the Console will sound a "Gong" and two
"Beeps".
Enter a user code and press [ OFF ] or [ CHIME ] to
disarm from Home Mode and/or stop the alarm
siren.
❇
If an alarm has occurred, multiple beeps will sound
after disarming and the sensor light for the
sensor(s) that caused the alarm will flash (switch to
Off Mode again or re-arm the Console to stop the
flashing alarm memory light).

SECURE EXIT

If the system is already in the Home Mode and
the user wants to exit the premises while leaving
someone inside with the system still in Home
Mode, enter a user code and press the [ HOME ]
key.
❇
A "gong" and two "beeps" will sound and the
HOME light will blink for 60 seconds. No exit
delay beeps will sound during the Exit Delay.
◆
The user can leave through a door with a delayed
perimeter sensor during the 60 second Exit Delay
without causing the Console to begin an Entry Delay.
◆
Re-entering during the silent Exit Delay will
extend the Exit Delay another 60 seconds (one
time only).
✍
NOTE: The Exit Delay time can be changed; see
the "Advanced Programming" section of this
manual.

HOME INSTANT MODE

If the system is already in the Home Mode and
the user wants to make all exit/entry sensors
instant, press the [ HOME ] key for 2 seconds.
❇
Two "gongs" and two "beeps" will sound and the
HOME light will blink continuously.
◆
Because all exit/entry sensors will now cause an
instant alarm when in Home Mode, the Console
must be disarmed before opening any exit/entry
delay door.
18

MANUAL BYPASSING OF SENSORS

◆
Manual bypassing of sensors in the Home Mode
allows arming of the system at night with open
windows, while still having perimeter protection
with other closed doors and windows.
◆
The Console will resist arming with open door or
window sensors.
❇
Four high-low beeps to warn the user that
something is open and the system will remain in
the previous mode.
❇
Lit sensor status indicators show which sensors
are open.
To manually bypass the open sensors, arm the
system again within 5 seconds.
❇
A "gong" and two "beeps" will sound, the HOME
indicator will light, and the open sensors will be
bypassed.
✍
WARNING: Bypassed sensors cannot cause an
alarm.
HOME MODE
START IN OFF
OR CHIME MODE
(OPTIONAL)
YOUR
USER
CODE
1 GONG
HOME
& 2 BEEPS
DONE
QUICK ARM
START IN OFF
OR CHIME MODE
HOLD
DOWN
HOME
1 GONG
& 2 BEEPS
DONE
SECURE EXIT
START IN
HOME MODE
(OPTIONAL)
YOUR
USER
CODE
1 GONG
HOME
& 2 BEEPS
DONE
HOME INSTANT
MODE
START IN
HOME MODE
HOLD
DOWN
HOME
2 GONGS
& 2 BEEPS
DONE