Test Mode - Linear DVS-2400 Installation & Programming Instructions

TEST MODE

◆
Even though this is a self-monitoring supervised
system, the National Burglar and Fire Alarm
Association recommends that all security
systems should be tested manually on a regular
basis.
◆
The Console must be in Off Mode before going
to Test Mode.
Switch the Console into Test Mode by entering a
user code and pressing [ TEST ].
❇
When the system is switched to the Test Mode,
the Console will sound a "Gong" and four
"Beeps".
Holding down the [ TEST ] button in Test Mode will
light all of the Console's indicators.
❇
The sensor status lights will flash for each sensor
programmed into the Console.
Go to each sensor and press its test button or
open and close the protected opening.
To test the wireless keypad, press the [ (A) ] key.
❇
The Console will make a "bing" sound as each
sensor is tested, followed by 1-3 beeps indicating
signal strength with 3 beeps being the strongest
signal.
❇
As each sensor is tested, the sensor status light
for the sensor will stop flashing and return to
showing the current status of the sensor.
Continue testing until there are no flashing status
lights.
✍
NOTE: If the Console is left unattended in Test
Mode, it will automatically switch back to Off Mode
after 3 minutes.
◆
When directly connecting (without a telephone
line) to the DVS-2400 with the RA-2400 remote
access software (Version 1.3 or later), press the
[ EMERGENCY ] key while in Test Mode to cause
the Console to connect to the modem.
SENSOR FUNCTION
AUTOMATION
EMERGENCY
PANIC
FIRE
PERIMETER
EXIT/ENTRY
INTERIOR
CHIME
2-BUTTON ARM/DISARM (LEFT)
2-BUTTON AUTOMATION (RIGHT)
EMERGENCY (BOTH)
2-BUTTON ARM (LEFT)
2-BUTTON DISARM (RIGHT)
EMERGENCY (BOTH)
ENVIRONMENTAL
INTERIOR HOME
† CAN BE HOME MODE USING PROGRAMMING STEP 50
‡ CAN BE CHIME MODE USING PROGRAMMING STEP 51
20
SENSOR OPERATION IN EACH CONSOLE MODE
OFF MODE
DEACTIVATED
DEACTIVATED
DEACTIVATED
LEFT BUTTON SWITCHES CONSOLE TO AWAY MODE †
IF ALARM HAS OCCURED, SWITCHES CONSOLE TO OFF MODE ‡
LEFT BUTTON SWITCHES CONSOLE TO AWAY MODE †
IF ALARM HAS OCCURED, SWITCHES CONSOLE TO OFF MODE ‡
DEACTIVATED
Sensor Function Table
CHIME MODE
ACTIVATES AND DEACTIVATES THE AUTOMATION OUTPUT
ARMED 24-HOURS - TRIGGERS EMERGENCY ALARM
ARMED 24-HOURS - TRIGGERS SILENT PANIC ALARM
ARMED 24-HOURS - TRIGGERS FIRE ALARM
CHIME
CHIME
DEACTIVATED
CHIME
ARMED 24-HOURS - TRIGGERS ANNUNCIATION ONLY
DEACTIVATED
TEST MODE
START IN OFF
(OPTIONAL)
YOUR
USER
CODE
1 GONG
TEST
& 4 BEEPS
DONE
HOME MODE AWAY MODE
INSTANT BURGLARY ALARM
DELAYED BURGLARY ALARM
(INSTANT BURGLARY ALARM
DEACTIVATED
UNLESS ACTIVATED DURING
ENTRY DELAY)
LEFT BUTTON SWITCHES TO OFF MODE ‡
RIGHT BUTTON SWITCHES TO OFF MODE ‡
INSTANT BURGLARY ALARM
FOLLOWER