ZyXEL Communications Prestige 792H User Manual page 133

LABEL
One Minute High
Maximum
Incomplete Low
Maximum
Incomplete High
TCP Maximum
Incomplete
Blocking Time
(min)
Back
Apply
Cancel
Firewall Configuration
This is the rate of new half-open sessions that causes the firewall to start deleting
half-open sessions. The default is "100". When the rate of new connection attempts
rises above this number, the Prestige deletes half-open sessions as required to
accommodate new connection attempts. The Prestige stops deleting half-open
sessions when the number is less than the One Minute Low.
This is the number of existing half-open sessions (default "80") that causes the
firewall to stop deleting half-open sessions.
The Prestige continues to delete half-open requests as necessary, until the number
of existing half-open sessions drops below this number.
This is the number of existing half-open sessions (default "100") that causes the
firewall to start deleting half-open sessions. When the number of existing half-open
sessions rises above this number, the Prestige deletes half-open sessions as
required to accommodate new connection requests. The Prestige stops deleting half-
open sessions when the number is less than the Max Incomplete Low.
Do not set Maximum Incomplete High to lower than the current Max Incomplete
Low number.
This is the number of existing half-open TCP sessions (default "10") with the same
destination host IP address that causes the firewall to start dropping half-open
sessions to that same destination host IP address. Enter a number between 1 and
256.
As a general rule, you should choose a smaller number for a smaller network, a
slower system or limited bandwidth.
When TCP Maximum Incomplete is reached you can choose if the next session
should be allowed or blocked. If you select Blocking Time, any new sessions will be
blocked for the length of time you specify in the next field (min) and all old
incomplete sessions will be cleared during this period.
If you want strong security, it is better to block the traffic for a short time, as it will give
the server some time to digest the loading.
Type the length of Blocking Time in minutes (1-256). The default is "0".
Click Back to return to the previous screen.
Click Apply to save your customized settings and exit this screen.
Click Cancel to return to the previously saved settings.
Table 9-2 Alert
DESCRIPTION
Prestige 792H User's Guide
9-7