Figure 27-6 Address Mapping Rules - ZyXEL Communications Prestige 792H User Manual

Prestige 792H User's Guide
Set Name= ?
Idx Local Start IP
--- ---------------
1.
2
3.
4.
5.
6.
7.
8.
9.
10.
If the Set Name field is left blank, the entire set will be deleted.
The Type, Local and Global Start/End IPs are configured in menu 15.1.1.1
Ordering Your Rules
Ordering your rules is important because the Prestige applies the rules in the order that you specify. When a
rule matches the current packet, the Prestige takes the corresponding action and the remaining rules are
ignored. If there are any empty rules before your new configured rule, your configured rule will be pushed
up by that number of empty rules. For example, if you have already configured rules 1 to 6 in your current
set and now you configure rule number 9. In the set summary screen, the new rule will be rule 7, not 9.
Now if you delete rule 4, rules 5 to 7 will be pushed up by 1 rule, so as old rule 5 becomes rule 4, old rule 6
becomes rule 5 and old rule 7 becomes rule 6.
FIELD
Set Name Enter a name for this set of rules. This is a required field. If this field
is left blank, the entire set will be deleted.
27-6
Menu 15.1.1 - Address Mapping Rules
Local End IP
---------------
Action= Edit
Press ENTER to Confirm or ESC to Cancel:

Figure 27-6 Address Mapping Rules

(described later) and the values are displayed here.
Table 27-3 Address Mapping Rules
Global Start IP Global End IP
--------------- ---------------
Select Rule=
DESRIPTION
Type
------
EXAMPLE
NAT_SET
NAT