Problems With Your Wine Cellar; Troubleshooting Guide - Summit VC60D Instruction Manual

PROBLEMS WITH YOUR WINE CELLAR

You can solve many common Wine Cellar problems easily, saving you the cost of
a possible service call. Try the suggestions below to see if you can solve the
problem before calling customer service.
PROBLEM
Appliance does not
operate.
Appliance is not cold
enough.
Appliance turns itself
on and off frequently.
The light does not
work.
Vibrations
The appliance seems
to make too much
noise.

Troubleshooting Guide

POSSIBLE CAUSE
• Appliance is not connected to a power
supply.
• The appliance is turned off.
• Tripped circuit breaker or blown fuse.
• The temperature is not set correctly.
• The ambient temperature could
require a higher temperature setting.
• The door was opened too often.
• The door was not closed completely.
• Door is not hermetically sealed.
• The condenser is dirty.
• The ventilation opening is blocked or
too dusty.
• The room temperature is higher than
average.
• A large number of bottles has been
added to the unit.
• The door is opened too often.
• The door is not closed completely.
• The door gasket does not seal
properly.
• Appliance is not connected to a power
supply.
• Tripped circuit breaker or blown fuse.
• The light was switched off at the
control panel.
• The appliance is not level.
• A rattling noise may come from the flow of refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds caused by the flow of
refrigerant in your appliance. If temperature fluctuations occur, the
contraction and expansion of the inner walls may cause popping and
cracking noises.
• The appliance has not been leveled properly.
19
REMEDY
• Connect the appliance.
• Switch on the appliance.
• Switch on circuit breaker or
replace fuse.
• Check the set temperature.
• Set a higher temperature.
• Do not open the door more
often than necessary.
• Close door properly.
• Check the door seal and
clean or replace.
• Clean the condenser when
necessary.
• Clear the obstructions and
clean the dust.
• Put the appliance in a cooler
place.
• Leave the appliance to work
for a while until the set
temperature has been
reached.
• Do not open the door more
often than necessary.
• Close the door properly.
• Check the door seal and
clean or replace.
• Connect the appliance.
• Switch on circuit breaker or
replace fuse.
• Switch on the light.
• Level appliance with the
adjustable feet.