Ubiquiti PowerBridge M10 Quick Start Manual page 9

7. On the front of the Dish, connect the Feed to the Rocket and
Dish using the four M4x12 Screw and Washer Assemblies.
Note:
at any time, especially during installation of the dish to
the pole. Always hold the dish or the brackets while
installing the product.
8. Select a mounting location for the Dish antenna and connect
the Stabilizer Brackets to the pole just below where the Dish will
be installed. Use two M10x100 Bolts, two M10 Washers, two M10
Spring Lock Washers, and two M10 Hex Nuts.
DO NOT handle the assembled unit by the feed
Hardware Installation
7