Lindy P16-IP User Manual page 55

Section 4 IP Access Configuration & Operation
IP auto configuration
With this option you can control if the P16-IP should obtain its network settings from a DHCP or
BOOTP server. For DHCP, select dhcp, and for BOOTP select bootp. If you choose none then
IP auto configuration is disabled.
IP address
IP address in the usual dot notation.
Subnet Mask
The net mask of the local network.
Gateway IP address
In case the P16-IP is accessible from networks other than the local one, this IP address must be
set to the local network router' s IP address.
Primary DNS Server IP Address
IP address of the primary Domain Name Server in dot notation. This option may be left empty;
however, the P16-IP will not be able to perform name resolution.
Secondary DNS Server IP Address
IP address of the secondary Domain Name Server in dot notation. It will be used in case the
Primary DNS Server cannot be contacted.
Remote Console and HTTPS port
Port number at which the P16-IP's Remote Console server and HTTPS server are listening. If
left empty the default value will be used.
HTTP port
Port number at which the P16-IP's HTTP server is listening. If left empty the default value will be
used.
Telnet port
Port number at which the P16-IP's Telnet server is listening. If left empty the default value will
be used.
Bandwidth limitation
The maximum network traffic generated through the P16-IP's Ethernet device. Value in Kbit/s.
Enable Telnet access
Set this option to allow access to ARA express using the Telnet Gateway (see the Section
called Telnet Console on page 36.)
Disable Setup Protocol
Enable this option to exclude the P16-IP from the setup protocol.
54