Lindy P16-IP User Manual page 40

Section 4 IP Access Configuration & Operation
Windows
Windows users should use the tool, RawWrite for
Windows, which is included on the supplied CD.
Launch RawWrite, you will see the window
opposite:
Insert your floppy disk into your floppy drive. Click
the Read tab and then click on
Select a name and destination for the floppy image
file and click the Read button. As the image is
written, you will see the progress as a percentage
figure in the bottom left hand corner.
When the image has been written you can upload it
to the P16-IP.
Uploading a Floppy Image
Click the Browse button and navigate to
the location of the image file, then click
the Upload button.
After the image has uploaded you will see the dialog below:
A virtual floppy drive will be installed on the host system and the image will be downloaded to
the virtual floppy drive from the P16-IP. You can access the virtual floppy drive in the same way
you would a regular drive.
You can download the image from the P16-IP to your remote system by clicking the Download
button.
Clicking Discard removes the virtual floppy image from the P16-IP and from the hosts system.
39