Table of Contents
Advertisement
User Manual
English
The default VLAN ID group for all ports is VID=1, this is to allow any port to be used
for web management communication with the CPU.
If you wish to isolate ports on a separate VLAN, then you must delete the ports from
VLAN=1 and create another VLAN ID. For example, below we have added ports 7 &
8 to VLAN ID=10 and ports 5 & 6 to VLAN ID=20.
After these changes, you can perform web management on any of the 4 ports on
VID=1. To perform web management on a port in another VLAN you must go to the
system configuration page and select Tag VLAN management group. Once you apply
the changes you must move the RJ-45 connection from port 1 to the port selected.
If you are not sure what port the CPU is active on then you can either:
1. Check for a password through the console port and the configuration of the IP
2. Reset the unit to factory default settings by holding in the reset button for five
seconds
Advertisement
Table of Contents
