Related Manuals for Lindy IPower Control 2x6
Summary of Contents for Lindy IPower Control 2x6
- Page 1 IPower Control 2x6 User Guide English LINDY No. 32656 www.lindy.co.uk © LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (August 2011)
-
Page 3: Package Contents
User Guide Introduction Thank you for purchasing the LINDY IPower Control 2x6 Switch. This Switch allows you to control the supply of power for up to 12 devices via a TCP/IP network. The Switch access is password protected through a web interface connected by serial or SNMP and is powered by two separate 16A phases, each powering 6 IEC C14 sockets. - Page 4 Network configuration by GBL_Conf.exe For changing the network properties manually, the program GBL_Conf.exe is required. This tool is available for free on our website www.LINDY.com. GBL_Conf.exe enables you to install firmware updates and to reset the IPower 2x6 back to its factory settings.
-
Page 5: Configuration - Power Ports
IPower 2x6 User Guide Configuration - Power Ports Label: A name with a maximum of 15 characters can be entered here for each Power Port. After power-up switch: Power Port’s switching state after a power-on can be defined as on, off, or remember last state. If switching on after power-up, wait...: A switching delay of a Power Port can be defined with a wait of up to 8191 seconds. -
Page 6: Configuration - Http
IPower 2x6 User Guide Configuration - HTTP HTTP Port: You can manually enter the HTTP port number, if necessary. Numbers range from 1 ... 65534 (standard: 80). To get access to the switch, you have to enter the port number behind the IP address: http://192.168.0.2:1720 Require HTTP Password: Password protected access can be activated here. -
Page 7: Configuration - Syslog
IPower 2x6 User Guide Configuration - Syslog Enable Syslog: You can select to have the syslog enabled or disabled. Syslog Server IP: If you enable the syslog you will need to enter the IP address of the Syslog server. Syslog Port: If syslog is enabled you will need to enter the port number that your Syslog server uses to receive syslog information. -
Page 8: Batch Mode
IPower 2x6 User Guide Switching via the push buttons The front of the Switch has two buttons, “select” and “ok”. Select: Pushing “select” once make the LED of Power Port 1 start to blink, which means that it is selected. Pushing the button again will select the next port. -
Page 9: Temperature Sensor
SNMP. The temperature sensor can be ordered as an optional extra, please contact LINDY for more information. Bootloader mode To activate the bootloader mode of IPower 2x6 press the buttons “select” and “ok” on the front of the Switch for three seconds. -
Page 10: Default Settings
IPower 2x6 User Guide Default settings In order to restore the default settings, the IPower 2x6 must be started in bootloader mode. The you will need to run the GBL_Conf.exe program. When you run Run GBL_Conf.exe, select the IPower 2x6 device which you would like to restore the settings on and click on the Program Deviceg →... - Page 11 Per ulteriori dettagli fare riferimento alla direttiva WEEE sul riciclaggio del proprio Stato. Per ulteriori dettagli fare riferimento alla direttiva WEEE sul riciclaggio del proprio Stato. No. 32656 www.lindy.com © LINDY ELECTRONICS L S LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDIT DITION (Aug 2011)