The Surface Of The Paper Is Dirty; The Back Side Of The Paper Is Dirty - Canon iPF8400 Basic Manual

iPF8400
Cause
You are printing on heavyweight paper or
paper that curls or wrinkles easily after ab-
sorbing ink.
The Ejection Guide is soiled.

The surface of the paper is dirty

The surface of the paper is dirty
Cause
The Paper Retainer is soiled.
You are using a paper that does
not dry easily.

The back side of the paper is dirty

The back side of the paper is dirty
Cause
The Platen has become dirty after borderless print-
ing or printing on small paper.
The Platen has become soiled because you have
set Width Detection to Off in the Control Panel
menu.
The Platen suction is too strong.
BordlessOversize is set to Standard in the Control
Panel menu.
Basic Guide
When printing on Canon Heavyweight Coated Paper or other paper-based media, choose a
VacuumStrngth setting of Strong or Strongest in the Control Panel menu. If rubbing still
occurs, in the Control Panel menu, use a higher Head Height setting.
(See "Adjusting the Vacuum Strength.")
(See "Troubleshooting Paper Abrasion and Blurry Images.")
When printing on CAD Tracing Paper or other film-based media, choose a VacuumStrngth
setting of Standard, Strong, or Strongest in the Control Panel menu. If rubbing still occurs,
in the Control Panel menu, use a higher Head Height setting.
(See "Adjusting the Vacuum Strength.")
(See "Troubleshooting Paper Abrasion and Blurry Images.")
Clean the Ejection Guide.
(See "Cleaning the Printer Exterior.")
Clean the Paper Retainer.
(See "Cleaning Inside the Top Cover.")
In the Control Panel menu, set Roll DryingTime to at least 1 min.
→
(See "Menu Settings.") User's Guide
When paper that does not dry easily is used for printing, it may curl during printing and touch the Out-
put Tray.
In this case, in the Control Panel menu, complete the settings for Dry time and Area in Scan Wait
Time.
However, note that printing will now take longer.
→
(See "Menu Settings.") User's Guide
Open the Top Cover and clean the Platen.
(See "Cleaning Inside the Top Cover.")
In the Control Panel menu, set CarriageScanWdth to Fixed.
(See "Menu Settings.")
Set Width Detection to On in the Control Panel menu, and then open the Top Cov-
er and clean the Platen.
(See "Cleaning Inside the Top Cover.")
Open the Top Cover and clean the Platen. After this, manually advance the roll on-
to the Platen before printing.
(See "Cleaning Inside the Top Cover.")
(See "Feeding Roll Paper Manually.")
In the Control Panel menu, reduce the level of VacuumStrngth.
(See "Adjusting the Vacuum Strength.")
Set BordlessOversize to Little in the Control Panel menu.
(See "Menu Settings.")
Corrective Action
→
User's Guide
→
→
User's Guide
→
→
User's Guide
Corrective Action
→
P.53
Corrective Action
→
P.53
→
User's Guide
→
P.53
→
P.53
→
User's Guide
→
User's Guide
→
User's Guide
The surface of the paper is dirty
User's Guide
User's Guide
115