Www.honeywelllifesafety.es - Honeywell NFS Supra Installation And Operating Manual

Conventional fire alarm control panel

Hide thumbs

Table Of Contents

Table of Contents

NFS Supra

ZONE INDICATORS

The system has a number of alarm detection zones which will correspond, in general, with

particular areas of the protected building.

In case of incidence in one of these zones, the zone led indicator, indicates their status. In case

of Fault, Disablement or Test in one zone, besides the yellow zone LED, the general state LED

of the specific event will light. If you enable access to Level 2 (Operator), LED zone will flash

latched (with the same frequency) as the general status LED of the relevant zone.

Zone Alarm (Red):

alarm condition in this

-Led flashing: There is a detector in alarm.

-Led On: There is a call point in alarm.

Check the alarm cause and press the Reset key (Access level 2) to make the system return to its normal status.

Zone Fault/Disabled/Test (Yellow):

Led flashing quickly (and Fault led also on): The zone is in fault condition. Check the zone wiring. Once the fault cause has been

cleared, press the Reset key (Access level 2) to make the system return to its normal status.

-Led On (and Disablement led on too). The zone is disabled. Enable the zone by pressing the Zone key (Access level 2) until the

zone yellow led is off.

-Led On (and Test led On too) / (flashing slowly with test led On in Access level 2): The relevant zone is being tested. Press the

Zone key (Access level 2) until the zone yellow led is off.

HLS-MN-025 v.04