Figure 3.6 Amt Configuration Setting - Advantech ARK-DS262 User Manual

– MEBx Debug Message Output: OEMFLag Bit 14: Enable MEBx debug
message Output.
– Un-Configure ME: OEMFLag Bit 15: Un-Configure ME without password.
– Amt Wait Timer: Set timer to wait before sending
ASF_GET_BOOT_OPTIONS.
– ASF: Enable/Disable Alert Specification Format
– Activate Remote Assistance Process: Trigger CIRA boot.
– USB Configure: Enable/Disable USB Configure function.
– PET Progress: User can Enable/Disable PET Events progress to receive
PET events or not.
– WatchDog: Enable/Disable WatchDog Timer.
USB Configuration: USB Configuration Parameters.
– Legacy USB Support: Enable Legacy USB support. AUTO option disables
legacy support if no USB devices are connected. DISABLE option will keep
USB devices available only for EFI applications
– EHCI Hand-off: This is a workaround for 0Ses without EHCI hand-off sup-
port. The EHCI ownership change should be claimed by EHCI driver.
– USB transfer time-out: The time-out value for Control, Bulk, and Interrupt
transfers. The choice: 1 sec, 5 sec, 10 sec, 20 sec
– Device reset time-out: USB mass storage device Start Unit Command time-
out. The choice: 10 sec, 20 sec, 30 sec, 40 sec
– Device power-up delay: USB mass storage device Start Unit Command
time-out.
ARK-DS262 User Manual

Figure 3.6 AMT Configuration setting

18