Sony SNC-RZ30N Service Manual page 6

2-4. Pan / Tilt Adjustments ............................................................................... 2-21
2-5. Procedure for SY-303 Board Replacement ............................................... 2-24
2-6. Overall Checking ...................................................................................... 2-26
2-7. Setting for Hyper Terminal ....................................................................... 2-30
2-8. Update of Software ................................................................................... 2-30
3. Troubleshooting
3-1. No image is displayed on the personal computer (referred to as PC hereafter)
(When the Power LED is lit) ....................................................................... 3-1
3-2. Initial operation of motor is normal but PC image and TV picture are NG
(When the Power LED is lit) ....................................................................... 3-3
3-3. Initial operation of motor and TV picture are normal but PC image is NG
(When the Power LED is lit) ....................................................................... 3-5
3-4. Initial operation of motor and PC image are normal but TV picture is NG
(When the Power LED is lit) ....................................................................... 3-6
3-5. Black spots, white spots and flaws on CCD ............................................... 3-8
3-6. Power LED on front panel does not light .................................................... 3-9
3-7. Operation failure of pan and tilt ................................................................ 3-10
2
2-4-1. Pan / Tilt Adjustments .............................................................. 2-22
2-4-2. Hole Sensor Detection .............................................................. 2-22
2-4-3. Phase Switch Fine Adjustment for PAN .................................. 2-22
2-4-4. Phase Switch Fine Adjustment for Tilt .................................... 2-22
2-4-5. Zoom and AF Checking ........................................................... 2-23
2-4-6. Iris Motor Check ...................................................................... 2-23
2-4-7. ICR Check ................................................................................ 2-23
2-4-8. Stabilizer Check ....................................................................... 2-23
2-4-9. Pan/Tilt Operation Check ......................................................... 2-24
2-5-1. Re-sticking of MAC Address Label ......................................... 2-24
2-5-2. Rewriting of Serial Number ..................................................... 2-24
2-6-1. Reconfirmation for Pan/Tilt Operations ................................... 2-27
2-6-2. Confirmation for Digital Image ............................................... 2-27
2-6-3. Confirmation for TV Monitor Images ...................................... 2-27
2-6-4. Confirmation for Sensor In and Alarm Out ............................. 2-27
2-6-5. Confirmation for PC Card Slot ................................................ 2-28
2-6-6. Confirmation for RS-232C ....................................................... 2-28
2-6-7. Confirmation for RS-485 ......................................................... 2-29
2-6-8. Confirmation for Reset Switch ................................................. 2-29
2-8-1. Debug mode ............................................................................. 2-30
2-8-2. Normal Mode ........................................................................... 2-31
3-7-1. Operation failure of pan ........................................................... 3-11
3-7-2. Operation failure of tilt ............................................................. 3-13
SNC-RZ30N/RZ30P (E)