IBM Enterprise Server S80 User Manual page 210

Table 1. Firmware Error Codes. (continued)
Error Code
20EE000C
25A80001
25A80002
25A80011
25A80012
192
S80 and S85 User's Guide
Description Action
Pointer to the Values normally found in non-volatile storage that point
operating system to the location of an Operating System were not found.
found in This can happen for two reasons, either your installed
non-volatile Operating System doesn't support storing the values or
storage. some event occurred that caused the system to lose
non-volatile storage information (drainage or
replacement of the battery). If you are running AIX, this
information can be reconstructed by running the bootlist
command specifying the device that the Operating
System is installed on. Please refer to your AIX
documentation for the exact syntax and usage of the
bootlist command.
In order to boot the Operating System so that the above
mentioned values can be reconstructed,power the
system down and power it back up again, this should
cause the system to look for the Operating System in
the devices contained in the custom boot list or in the
default boot list, depending on the condition of the
system. If this is not successful, modify the Boot
Sequence (also known as boot list) to include devices
that are known to contain a copy of the Operating
System. This can be accomplished by using the System
Management Services Menus. For example, select a
hard disk known to have a copy of the Operating
System as the first and only device in the boot
sequence (boot list) and attempt to boot again.
Init-NVRAM Errors reported against NVRAM can be caused by low
invoked, ALL of battery voltage and (more rarely) power outages that
NVRAM initialized occur during normal usage. These errors are generally
warnings that the NVRAM data content had to be
re-established, and do not require any further action
unless the error is persistent. When one of these errors
occurs, any system customization (for example, boot
device list) information may have been lost. The system
may need to be reconfigured. Call your service
representative if the problem is persistent.
Init-NVRAM Refer to Action under error code 25A80001.
invoked, some
data partitions
may have been
preserved.
Data corruption Refer to Action under error code 25A80001.
detected, ALL of
NVRAM initialized
Data corruption Refer to Action under error code 25A80001.
detected, some
data partitions
may have been
preserved.