Device Installation - Dahua IPC-HFW2100P Series Quick Start Manual

Please follow the steps listed below to install the device. Please refer to Figure 2-1 and Figure
2-2 for reference.
Paste the installation map on the surface of the wall or the ceiling.
Dig the installation holes according to the installation map.
Open the accessories bag and then take the expansion bolt out. Insert the expansion
bolt into the installation holes.
Take the screws from the accessories bag and then use them to secure the device on
the installation surface of the wall or the ceiling.
Connect the corresponding cables.
Use the cross-head screwdriver to loosen the adjust screw.
Turn the device in different directions to make it suitable for the monitor position.
Use the cross-head screwdriver to fix the adjust screw firmly.
Figure 2-1
3