Reel Control; Reel Switches; Steering Wheel (Gk Iv Units Only) - Jacobsen Greens King IV 62287 Parts & Maintenance Manual

3 ADJUSTMENTS

3.12 REEL CONTROL __________________________________________________________

Adjust the reel control lever linkage so the reels
disengage when they reach the raised position.
1. Remove front cowling and raise mowers. Shift all
reel control levers to "OFF" and stop engine.
2. Adjust link (R) so there is 1/32 to 1/16 in. (0.8 to
1.6 mm) clearance between the bottom of the
shoulder bolt (S) and the bottom of the slot in link
(R).
3. Remove all hardware holding link (R) in place then
loosen nut (T) and adjust the link.
4. Tighten nut (T) against the link. Reassemble all
components and tighten hardware.

3.13 REEL SWITCHES__________________________________________________________

The reel lever linkage actuates two electrical switches
located under the levers. Check that both switches are
closed when all reel levers are in their NEUTRAL
position.
1. Check and make sure switches are wired correctly.
Refer to Figure 3K and labels attached to wires for
correct terminal placement
2. When any of the reel levers are moved to the
forward position, Reel Switch (Wires A and B)
should open, and Backlap Switch (Wires C and D)
ahould remain closed.
3. When any of the reel levers are moved to the
reverse position, Backlap Switch (Wires C and D)
should open and and Reel Switch (Wires A and B)
should remain closed.

3.14 STEERING WHEEL (GK IV UNITS ONLY) ______________________________________

1. Loosen cable mounting nut (BB) or (CC) as neces-
sary and tighten opposite nut until steering wheel is
square with the frame and tractor runs straight
ahead.
2. After steering wheel is adjusted, adjust both cable
mounting nuts until there is 1/2 to 5/8" (13 to 16
mm) deflection in center of cables with a 10 pound
(4.5 Kg) pull.
GB-12
T
S
1/32 to 1/16"
(0.8 to 1.6 mm)
B
C
D
1/2" to 5/8"
(13-16 mm)
R
Figure 3J
Backlap Switch
Reel Switch
A
Figure 3K
BB
CC
Figure 3L