Antisway Spring; Accelerator Pedal; Brake Pedal - Jacobsen Greens King IV 62287 Parts & Maintenance Manual

3 ADJUSTMENTS
3.5

ANTISWAY SPRING________________________________________________________

1. The antisway spring (C) should be tight but not
under stress.
2. Loosen both nuts on the adjusting rod then adjust the
rear nut as necessary.
3. When properly adjusted, tighten nuts against
bracket.
3.6

ACCELERATOR PEDAL ____________________________________________________

1. The top of the pedal should not be less than 2-3/4"
(70 mm) from the floorboard when pedal is fully
depressed.
2. Loosen locknut (D) and adjust carriage bolt (E) to
obtain the correct distance between pedal and
floorboard.
3.7

BRAKE PEDAL ___________________________________________________________

1. Drive straight forward with traction lever in "MOW"
position and throttle in "SLOW" position. Depress
Brake pedal. If the brake pedal comes too close to
the floorboard, check the amount of brake lining left.
a. Replace lining.
b. Adjust nut (F) to obtain a distance of 3-5/16"
(84 mm), between rod pivot points, (when brakes
are new), and to compress spring to 31/32" (24
mm).
2. If machine pulls right, turn adjusting nut (F) on left
side clockwise. If machine pulls left, turn adjusting
nut (F) on left side counterclockwise. Do not
compress either spring past 7/8" (22 mm)
GB-10
C
2-3/4" (70 mm)
Fully Depressed
D
GKV-2
Figure 3E
E
GKV-3
Figure 3F
3-5/16"
(84 mm)
31/32"
(24 mm)
F
GKV-4
Figure 3G