Table of Contents
Advertisement
INSTALLATION
Choose a suitable site for the base unit
Make sure it is not near to another telephone, nor to other electrical equipment.
Plug the mains power lead
and the telephone line cord
into the rear of the base unit
1. Plug the mains adapter
into a 230 V AC, 50 Hz
mains socket, with the
switch on the socket set to OFF
Note: The illustration of adaptor
may vary from country to country.
2. Switch on mains power at the socket
3. Fit the batteries in the handset(s)
Insert the battery pack as shown. Fit the battery compartment cover,
Sliding it until it clicks firmly into position.
4. Connect the base unit to the telephone line
Switch off power at the mains socket.
Insert the telephone line plug into the socket.
Switch mains power back on
Make sure the mains socket is
switched on if you want to use
the phone---it will not work
without electrical power.
Note:
The charge pod does not have a connection to the
1.
telephone line.
2. When Handset is placed onto the charge pod, a red light
lights up to indicate it is charging.
The illustration of telephone's socket may vary from
3.
country to country.
Use the plug to raise the shutter
before pushing it into the socket
6
Advertisement
Table of Contents
