Table of Contents
Advertisement
Press the OK button, the display shows PIN?;
2.
Key in your PIN number and press the OK button, then UP/DOWN button to the location
3.
FLASH?
Press the OK button ,the display shows SHORT? . You may press UP/DOWN button to select
4.
LONG?
Press the OK button to confirm.
5.
RESETTING THE SYSTEM
If you have set a PIN and forgotten it, you need to reset the system. The PIN will be reset to 0000.
If you reset the system, you will lose all stored information (including numbers in memory) and all
features will return to their default settings. You need to register the handset to the base unit
again.
While you are resetting the system, you should disconnect the telephone line cord from the back of
the base unit, so you won't be interrupted by incoming calls. To reset the system without the PIN:
1. Disconnect the power lead from the back of the base unit
Press and hold the HANDSET LOCATOR button in the base unit ,at the same time connect
2.
the power lead into the back of base unit. Release the LOCATOR button after you hear
"beep" sound for five times. The IN USE light on base unit lights during this whole process.
3. After 2~3 seconds ,you can hear "beep" sound for two times again and the IN USE light goes
off
Disconnect the power lead from base. Reconnect and you will hear confirmation tone from
4.
the base unit.
HANDSET REGISTRATION
Your DDP-650 is supplied with the handset already registered to the base unit, and you shouldn't
need to register it. But if you've bought extra handsets separately, you'll need to register each one
to your original base unit. Maximum 4 handsets can be registered to one base.
To register a handset
Press and hold the Handset locator button on the base unit for a while, until you hear
1.
"beep" sound twice continuously.
Press the MENU button, then press UP/DOWN button to the location REGISTER
2.
Press the OK button, then press UP/DOWN button to the location SUB BASE
3.
Press the OK button again
4.
The display shows BASE? 1 2 3 4. Key in a base unit number
5.
The display shows SEARCH + selected number
6.
Then shows the ID of the base unit after 3~4 seconds.
Press the OK button again
7.
The display shows PIN?
8.
Key in your pin (default 0000) and press OK to confirm.
9.
If the display says NOT REG, check to see if you key in the correct PIN, then
10.
repeat the registration procedure again from step 1.
INTERCOM AND TRANSFER
To make an intercom call
Press the INT button
1.
2. Key in the number of the other handset
14
Advertisement
Table of Contents
