Table of Contents
Advertisement
On the other handset's display, your number appears, and the INT symbol flashes. Then the other
handset user presses the CALL button to connect the call.
For details of how to change the ringing melody and volume for intercom calls, see "INT MELODY"
and "INT VOLUME" on "HANDSET SETTING" part.
To end an intercom call
Press the CALL button on your handset
The other person will hear Busy tone, and should also press the CALL button to hand up.
To transfer the outside call to another handset (if you have two or more handsets):
•
Press the INT button and key in the number of the other handset.
•
The outside call is put on hold. When the other handset answers, you can speak to the
user. If the other handset does not answer, you can get back to the outside call by pressing
the INT button again.
To transfer the outside call to another outside phone:
•
Press the Recall
•
The first party is put on hold. When second party answers, you can speak to the user, then
press the CALL button to hang up and transfer the call.
Note: Network Dependant
TROUBLESHOOTING
Always check first that:
•
You have followed the steps listed on pages to install and set up your DDP-650.
•
All connects are firmly inserted in their sockets.
•
Mains power is switched on at the socket.
•
The handset's batteries are correctly and securely installed, and are not run down.
If you experience difficulties with the working of your DDP-650, refer to the advice given below.
I cannot make or answer calls.
Check that the handset unit's mains power adapter is plugged in and power is switched on. The
handset unit needs mains power for normal operation of the phone-not just charging the batteries.
Make sure you are using the telephone line cable that was supplied with your DDP-650. Other
telephone line cables might not work.
Check the battery level symbol on the display. If it is low, replace the handset on the base unit or
charger pod to recharge the batteries.
Switch off power at the mains socket, wait for a few seconds and then switch back on. This may
solve the problem.
If you still can't make calls, try re-registering the handset.
When I press keys on the handset, nothing happens.
Make sure the batteries are fitted in your handset. If the battery level symbol on the display shows
"low", recharge the batteries.
Check whether there's a key symbol on the display. If so, the keypad is locked. Turn to the user
manual to find out how to unlock it.
When I press keys on the handset, digits appear on the display, but I can't
make an outside call.
Call barring may have been set, see the user manual for more information.
Try moving the handset closer to the base unit.
button and key in the call number you want to transfer.
15
Advertisement
Table of Contents
