Alarm Configuration: Uc1000 Controller Only - King Quest VQ4100-OE Owner's Manual

12

ALARM CONFIGURATION: UC1000 CONTROLLER ONLY

This unit is shipped from the factory with the alarm feature in the ON condition. If you wish to have the alarm in the ON
condition, you can skip this section.
1. Press POWER to turn on UC1000 controller. Wait for the lights to stop flashing and for the COAX
CONNECTION light to remain on.
2. Simultaneously press and hold POWER and SCAN for five seconds. Controller begins beeping.
• Single Beep (beep...beep...beep)
• Double Beep (beep beep...beep beep)
3. Press and release SCAN to toggle between the on and off conditions.
Beep pattern will change to indicate new condition.
4. When alarm is in desired condition, press and hold SCAN for 5 seconds to exit Alarm Mode.
Alarm condition will be saved. COAX CONNECTION light will turn solid and
SCAN PROGRESS lights will stay off.
5. Press POWER to turn controller off.
When alarm is enabled: If the coax cable is disconnected from the antenna unit or the controller while the system is
Page 24
turned on or in standby mode, the controller will sound an audible alarm.
To turn off the alarm when it is sounding, press POWER until the controller turns off.
Alarm is OFF.
Alarm is ON.