King Quest VQ4100-OE Owner's Manual page 10

4. On the receiver remote, press MENU, 6, 1, 1.
5. Highlight "Check Switch."
Press SELECT on your remote.
NOTE: Some receivers may prompt you to select
"Check Switch" a second time to initiate
the test.
6. Make sure "SuperDISH" and "Alternate" boxes
are NOT selected.
NOTE: Not all receivers will display a screen with
options that include "SuperDISH" and
"Alternate" boxes.
7. Highlight "Test."
Press SELECT on your remote.
The receiver will perform a check switch test, during which time the antenna will periodically move
back and forth between satellites. This process can take a little while so PLEASE BE PATIENT.
Do not block signal to the antenna during this time. The antenna requires a direct line of sight to the satellite.
8. When test is complete, a screen similar to one below or on the next page should appear. After
screen verification, continue with check switch test procedure on next page.
Because receivers are always changing, screen graphics may vary.
Page 8
MUST SHOW
"SW21"
NO "X"s
Screen graphics may vary.
DISH SD