Operation; Ka Band Satellites At 99° And - King Quest VQ4100-OE Owner's Manual

If you chose Tailgater Mode in the antenna configuration section, DO NOT use the instructions on this page.
Go to the Tailgater Mode instructions on page 14.
Your local channels may not be available when traveling outside your home area.
The KING Quest will not receive channels broadcast from DIRECTV's Ka band satellites at 99° and 103°.
IMPORTANT!
The antenna unit requires a "direct
line of sight" to the satellites in the
southern sky for signal reception.
Any tall objects can block the signal
from reaching the antenna.
If you chose Tailgater Mode, do not use these instructions.
POWER UP
1. Press POWER to turn on UC1000 controller.
• All lights will turn on briefly.
• The COAX CONNECTION light will flash 10 times and the SCAN PROGRESS lights will flash 3
times to indicate the currently selected service configuration and then turn off.
• If the unit is operating properly, the COAX CONNECTION light will remain on and all other lights
will turn off.
2. Turn the TV and satellite receiver on.
• Antenna is now ready to scan for satellites. Go to next page.
Page 10
8

OPERATION

Go to page 14 instead.