Receiver Configuration: Directv; Receiver Configuration: Dish And Bell Tv - King Quest VQ4100-OE Owner's Manual

The KING Quest will not work with SWM only receivers.
For receiver compatibility, visit www.kingconnect.com/support/receivers/.
In the receiver's satellite set up menu screens, change the switch and dish type settings to:
DIRECTV SD
Switch Type: 02:Multiswitch
DIRECTV SD with Locals
Switch Type: 02:Multiswitch
If your receiver does not offer one of these settings, call KING at (952) 922-6889 ext. 173 for
assistance.
After setting your receiver for either service as described above. . . . . . . . . . . go to page 10.
6
DISH subscribers with the following receivers:
ViP211z •
and who chose Tailgater Mode on the previous page . . . . . . . . . . . . . . . . . . go to page 14.
All other DISH and Bell TV subscribers:
After you have successfully configured your antenna, you must
configure your receiver for mobile use by running a check switch test . . . . . . . go to page 7.
For receiver compatibility, visit www.kingconnect.com/support/receivers/.
Dual tuner receivers or receivers with built-in recorders are not recommended and will not have full functionality when
used with the KING Quest antenna. Your local channels may not be available when traveling outside your home area.
Page 6
5

RECEIVER CONFIGURATION: DIRECTV

RECEIVER CONFIGURATION: DISH AND BELL TV

ViP211k • ViP211
Dish Type: 01: 18" Round
Older receivers: choose round dish-1 satellite
Dish Type: 02: 3-LNB (18 x 20")
Older receivers: choose oval dish-2 satellites
• 411