Table of Contents
Advertisement
The KING UC1000 Controller is factory preset for DISH HD and SD (satellites 110, 119 and 129).
If this is your desired service option, you do not need to configure your antenna. Go to section 6.
If you wish to use a different DISH service option, or if you have DIRECTV or Bell TV service, you will need to
reconfigure the antenna as shown below.
Antenna configuration is a one time procedure that MUST BE COMPLETED before using your
KING Quest antenna. To configure your antenna, do the following:
1. Press POWER to turn on the controller. Wait for the lights to stop flashing and for the COAX
CONNECTION light to remain on.
2. Press and hold SCAN for five seconds. The COAX CONNECTION light and the SCAN
PROGRESS lights that indicate the currently selected service will begin flashing.
3. Press SCAN repeatedly to scroll thru the available service options.
4. When the correct lights turn on to show your desired antenna configuration, press and hold
SCAN for five seconds to save in memory.
All SCAN PROGRESS lights will turn off and the COAX CONNECTION light will stop flashing
and remain on.
5. Continue on next page. (If just verifying antenna configuration, turn controller off.)
If you have a DISH receiver ViP211z, ViP211k, ViP211 or 411, FIRST choose the Tailgater Mode setting
as instructed on these two pages, and then continue with Tailgater Mode (page 14).
To verify the current antenna configuration without changing it, perform steps 1, 2 and 5.
4
ANTENNA CONFIGURATION
Page 5
Hide quick links:
Advertisement
Table of Contents
