Tailgater Mode - King Quest VQ4100-OE Owner's Manual

You must have chosen Tailgater Mode on page 5.
Your local channels may not be available when traveling outside your home area.
IMPORTANT!
The antenna unit requires a "direct
line of sight" to the satellites in the
southern sky for signal reception.
Any tall objects can block the signal
from reaching the antenna.
If your receiver is NEW AND UNACTIVATED, START HERE.
1. If your UC1000 controller is not on, press POWER and wait for the COAX CONNECTION light to
remain on.
2. Plug your receiver and TV into a 110 volt AC power source.
The green power light on your receiver should illuminate or begin cycling on and off.
Wait for the green light to turn solid. This may take up to two minutes.
If it does not turn solid, power on your receiver using the front panel POWER button.
(On ViP211z models, this is located behind the door panel.)
3. Turn on your TV.
In your TV's input selection menu, choose the input that matches the connection from your
receiver (example: if using an HDMI cable from your receiver, choose the HDMI input on your
TV). See your TV owner's manual for details.
Page 14
11

TAILGATER MODE

If not, go to page 20.