Checking Fuel System - PowerTec 25A Owner's Manual

Outboard motor
Table of Contents

Advertisement

Maintenance
of the spark plug can indicate something
about the condition of the engine. For exam-
ple, if the center electrode porcelain is very
white, this could indicate an intake air leak or
carburetion problem in that cylinder. Do not
attempt to diagnose any problems yourself.
Instead, take the outboard motor to a
Powertec dealer. You should periodically re-
move and inspect the spark plug because
heat and deposits will cause the spark plug
to slowly break down and erode. If electrode
erosion becomes excessive, or if carbon and
other deposits are excessive, you should re-
place the spark plug with another of the cor-
rect type.
Standard spark plug:
25A B7HS-10
25A B7HS-10
30A B8HS-10
30A B8HS-10
30A B8HS-10
25A B7HS-10
30A B8HS-10
Before fitting the spark plug, measure the
electrode gap with a wire thickness gauge;
adjust the gap to specification if necessary.
1. Spark plug gap
2. Spark plug I.D. mark (NGK)
44
Spark plug gap:
0.9–1.0 mm (0.035–0.039 in)
When fitting the plug, always clean the gas-
ket surface and use a new gasket. Wipe off
any dirt from the threads and screw in the
spark plug to the correct torque.
Spark plug torque:
25.0 Nm (18.4 ft-lb) (2.55 kgf-m)
NOTE:
If a torque-wrench is not available when you
are fitting a spark plug, a good estimate of
the correct torque is 1/4 to 1/2 a turn past fin-
ger-tight. Have the spark plug adjusted to the
correct torque as soon as possible with a
torque-wrench.

Checking fuel system

WARNING
Gasoline and its vapors are highly flam-
mable and explosive. Keep away from
sparks, cigarettes, flames, or other
sources of ignition.
WARNING
Leaking fuel can result in fire or explo-
sion.
Check for fuel leakage regularly.
If any fuel leakage is found, the fuel
system must be repaired by a qualified
mechanic. Improper repairs can make
the outboard unsafe to operate.
Check the fuel lines for leaks, crack, or mal-
function. If a problem is found, your Powertec
dealer or other qualified mechanic should re-
pair it immediately.

Advertisement

Table of Contents
loading

Related Products for PowerTec 25A

This manual is also suitable for:

30a

Table of Contents