Table of Contents
Advertisement
Tilt lock mechanism
The tilt lock mechanism is used to prevent
the outboard motor from lifting out of the wa-
ter when in reverse gear.
1. Tilt lock lever
To lock it, set the tilt lock lever in the lock po-
sition. To release, push the tilt lock lever in
the release position.
Tilt support knob
To keep the outboard motor in the tilted up
position, push the tilt support knob under the
swivel bracket.
1
Basic components
Top cowling lock lever(s) (turn type)
To remove the engine top cowling, turn the
lock lever(s) and lift off the cowling. When in-
stalling the cowling, check to be sure it fits
properly in the rubber seal. Then lock the
cowling again by returning the lever(s) to the
lock position.
1. Top cowling lock lever(s)
Warning system
CAUTION:
Do not continue to operate the engine if a
warning device has activated. Consult
your Powertec dealer if the problem can-
not be located and corrected.
Overheat warning
This engine has an overheat warning device.
1
13
Advertisement
Table of Contents
