Fuel Joint; Fuel Gauge; Fuel Tank Cap; Air Vent Screw - PowerTec 25A Owner's Manual

Outboard motor
Table of Contents

Advertisement

fuel tank, its function is as follows.
WARNING
The fuel tank supplied with this engine is
its dedicated fuel reservoir and must not
be used as a fuel storage container. Com-
mercial users should conform to relevant
licensing or approval authority regula-
tions.

1. Fuel joint

2. Fuel gauge

3. Fuel tank cap

4. Air vent screw

Fuel joint
This joint is used to connect the fuel line.
Fuel gauge
This gauge is located on either the fuel tank
cap or on the fuel joint base. It shows the ap-
proximate amount of fuel remaining in the
tank.
Fuel tank cap
This cap seals the fuel tank. When removed,
the tank can be filled with fuel. To remove the
cap, turn it counterclockwise.
Air vent screw
This screw is on the fuel tank cap. To loosen
the screw, turn it counterclockwise.

Remote control

The remote control lever actuates both the
shifter and the throttle. The electrical switch-
es are mounted on the remote control box.
2
1
1. Power trim and tilt switch
4

2. Remote control lever

3
3. Neutral interlock trigger
4. Neutral throttle lever
5. Main switch / choke switch
6. Engine stop lanyard switch
7. Throttle friction adjuster
Remote control lever
Moving the lever forward from the neutral po-
sition engages forward gear. Pulling the le-
ver back from neutral engages reverse. The
engine will continue to run at idle until the le-
ver is moved about 35° (a detent can be felt).
Moving the lever farther opens the throttle,
and the engine will begin to accelerate.
Basic components
7

Advertisement

Table of Contents
loading

Related Products for PowerTec 25A

This manual is also suitable for:

30a

Table of Contents