Fan Shroud; Oven Door; Oven Door - Disassembly - Fisher & Paykel Titan aerotech OD301US Service Manual

7.19 Fan Shroud

Location: Rear of oven cavity.
Removal
(a) Remove shelves and utensils.
(b) Remove two screws securing top of shroud.
Note: Hold the shroud when removing screws as it will fall towards you.
(c) Pull the shroud from the two tongue slots at the bottom of the oven cavity.
(d) The shroud can now be removed from the oven cavity.
Re-assembly
(a) Re-fit in reverse manner.
(b) Follow re-assembly procedure. (Refer to Section 7.5).

7.20 Oven Door

Removal
(a) Open the oven door fully.
(b) Pull the hinge clips on the door hinge towards you, on to the hooks.
(c) Raise door slightly, holding on to either side near handle. Make sure that the
hinge clips stay on the hooks.
(d) Lift out the oven door and hinges.
Re-assembly
(a) To replace door, place hinge arms into hinge slots. Push the hinges in as far as
they will go.
(b) Ensure oven door is fully open and push the hinge clips away from you.
(c) Raise the door slightly and ensure the hinge clips are released from the hooks.
Door can now be closed
7.21 Oven Door – Disassembly
To separate door inner and door outer assemblies:
(a) Remove door from oven. (Refer to Section 7.20).
(b) Lay door face down on table.
Note: If placing the oven door face down use foam blocks or similar to avoid
marking the door surface
(c) Remove four hinge screws on bottom edge of door and eight retaining screws
down sides of door.
Note: A spare screw and washer kit can be ordered from the Parts Manual.
(d) Lift off door inner assembly.
- 59 -