Control Without Remote Control - Ten-Haaft Oyster Operating Instructions Manual

5 Control without remote control

The two keys on the satellite mouse (see graphic on page 11 below)
allow the following basic functions of the receiver to be controlled
without the remote control:
Change to the next channel in the channel list.
Change to the previous channel in the channel list.
/ Pressing both keys briefly at the same time toggles
between RADIO and TV mode.
Pressing both keys longer will cause the antenna to
retract und the system to switch off. This corresponds
to pressing the red stand-by key (ON/OFF) on the
remote control.
When in stand-by mode, a brief press on both keys
switches the system back on.
Another control element is the master switch on the front of the
receiver. In position "0" or "OFF" the complete system is disconnected
from the vehicle's power supply. The switch must be in position "I" or
"ON" for the system to operate.
The antenna will only retract automatically by command of the control
line (terminal 15/ignition) if the master switch is set to "I" or "ON".
Should the system no longer respond to commands, set the master
switch to "0" for approx. 10 seconds and then back to "I" to reboot the
operating software of the receiver.
Left satellite-
mouse key
Remote-control
receiver
Display Right satellite-
mouse key
11
Satellite-mouse
connector (RJ-45)